P3D V4.3 Autogen Loading Problem

[emilsnersrud]

Hello, during departure and cruise I haven't any problem with autogen. But during approach and landing, there is no Autogen loading. I tend to fly faster than can load. When locking my frames on 50 FPS, everything loads in. But of the course, I sacrifice a lot of FPS. Is it another solution to this

Specs:I7-8700 CPU 3.20GHz, 16,0GB RAM, Nivida GeForce GTX 1070 Ti

[Martyson]

Hello, during departure and cruise I haven't any problem with autogen. But during approach and landing, there is no Autogen loading. I tend to fly faster than can load. When locking my frames on 50 FPS, everything loads in. But of the course, I sacrifice a lot of FPS. Is it another solution to this

Specs:I7-8700 CPU 3.20GHz, 16,0GB RAM, Nivida GeForce GTX 1070 Ti

Are you flying into a default airport?

Which aircraft are you using (default or payware)?

Could you do a short approach video to show the problem.

Possibly other pilots could test it on their setup.

[emilsnersrud]

Hey, I am flying into payware airports such as Valencia and Salzburg in the 737 NGX.

Some pictures of my problem:

Picture 1: http://prntscr.com/lbzwf6
Picture 2: http://prntscr.com/lbzw4s

As you can see in picture 1 I am very close to the autogen border where it hasn't loaded yet. While in picture 2 taken some few seconds later you can see the autogen has loaded the scenery quite close.

My settings:
Display- http://prntscr.com/lbzxs5
World- http://prntscr.com/lbzxwk
Lightning- http://prntscr.com/lbzxyu
Weather- http://prntscr.com/lbzy1d

My addons:
http://prntscr.com/lbzy45

[Martyson]

Ok, in your original post I assumed zero autogen:
" But during approach and landing, there is no Autogen loading."

[emilsnersrud]

I may have formulated my question a little bit tricky. But I have autogen, but i find it slow

[AnkH]

@emilsnersrud: you basically found already the only "solution" for the moment: lock the FPS inside your sim and dont go to high regarding autogen draw distance and density settings. You have to sacrifice some FPS, yes, but in the end, if you find your sweet spot regarding FPS limit and monitor refresh rate, you will have a more fluent and smooth sim on top of everything. Currently, there is no way to avoid this autogen loading bug when using "unlimited FPS" unless you go down with the autogen draw distance to "medium" or lower.