Hanging points

[Simu67]

Hi,

I'm simming with V3.2, Windows 10, 6 core 5930K@4.4 ghz, GtX680 4 Go, 16 go RAM and triple 22" in surround mode @5040X1050, all the drives are only SSD.
I'm using FSUIPC, ASN, REX, ORBX trees, all ORBX regions, ORBX Global, ORBX vector and a lot of Orbx add-ons.
I only fly with stock airplanes.

I can say the result is OK, with volumetric fog, HDR, a few shadows, it is very nice. Over PNW, i can fly in this area where i have a lot off airport add-ons with better resuts as i did with V2.5. I have a few OOMs, but these occur rarely. Thank you LM !

But, i can see there are points in the world, where the sim hangs for 4 or 5 seconds and i see drive activity. Each time i am going through these points, the sim hangs, and it occurs at all altitudes. This is ennoying, and the more i install scenery add-ons, more the hanging is long.

A good point to find such hanging location is NZMF Milford Sound, on the runway 500 metres from the coast. I had it till before installing the ORBX NZMF add-on. I have up and there such hangings in the world, in regions where there are no add-ons (Eg : over Sahara).

I don't know what it is exactly and if there is a solution.

Any idea ?

best regards

[drewmtb29]

I have a thread on this, Mike from LM is involved now. Similar spec PC and add ons as you so maybe we can figure this out together. Have you tried disabling FSUIPC autosave?

[Simu67]

Hi,

Glad to see i'm not alone.

I'll try to disable it, and give advice.

Regards

[Simu67]

Hi,

No effect, this logical : the sim hangs each time i am at exact places.

Any idea ?

[Mike LM]

Because you're experiencing similar issues, please post about them in the same thread. Here is the other thread.

- Mike