CH-53E Startup Procedure
CH-53E Startup Procedure
On start up both CH-53 Navy and Marine engines shut down and Ctrl-E will not start the engine? Also there is no sound for the Marine CH-53. The other Helicopters work just fine. This is a clean install of P3DV4 since 4.2 crashed on my computer. I am hoping someone has a solution other than reinstalling the client and content. Any help would be appreciated.
-
Clifton Crane
- Lockheed Martin
- Posts: 1207
- Joined: Tue Sep 25, 2012 2:34 pm
Re: CH-53E Default Helo
Hello,
The CH-53E has a specific start up procedure. This is described in the "CH-53E Quick Start Guide.pdf" manual located in the following directory of your P3D installation (default shown for example):
%PROGRAMFILES%\Lockheed Martin\Prepar3D v4\SimObjects\Rotorcraft\CH-53E\manual
There is also an auto-start button located on one of the 2D overhead panels. You should be able to access it by pressing Shift+3.
Hope this helps!
The CH-53E has a specific start up procedure. This is described in the "CH-53E Quick Start Guide.pdf" manual located in the following directory of your P3D installation (default shown for example):
%PROGRAMFILES%\Lockheed Martin\Prepar3D v4\SimObjects\Rotorcraft\CH-53E\manual
There is also an auto-start button located on one of the 2D overhead panels. You should be able to access it by pressing Shift+3.
Hope this helps!
Clifton Crane
Prepar3D® Software Engineer Sr.
Prepar3D® Software Engineer Sr.
Re: CH-53E Startup Procedure
Thank You for the information Clifton, I will give that a try. I am still not sure what happened to the sound on the Marine helicopter?
