Start/Resume and Stop/Freeze PDUs
Posted: Thu Oct 14, 2021 9:09 pm
Good day,
Our team is currently using v4.5 and is in the process of upgrading to v5.2. I was very interested in the DIS PDU support shown below.
Simulation Management
Start/Resume PDU
Stop/Freeze PDU
I tried to test if Prepar3d will react to a broadcast (from an external source) of the Start/Resume and Stop/Freeze PDUs. I predicted that the PDUs would pause/resume the simulation, but nothing happened to Prepar3d. I then paused/resumed the prepar3d simulation and used Wireshark to notice that it did not broadcast out those PDUs. Is there something I'm doing wrong here?
Very respectfully,
Dillon Tryhorn
Our team is currently using v4.5 and is in the process of upgrading to v5.2. I was very interested in the DIS PDU support shown below.
Simulation Management
Start/Resume PDU
Stop/Freeze PDU
I tried to test if Prepar3d will react to a broadcast (from an external source) of the Start/Resume and Stop/Freeze PDUs. I predicted that the PDUs would pause/resume the simulation, but nothing happened to Prepar3d. I then paused/resumed the prepar3d simulation and used Wireshark to notice that it did not broadcast out those PDUs. Is there something I'm doing wrong here?
Very respectfully,
Dillon Tryhorn