On my old P3D V2.4 I used to adopt 6 X 24” screens in “full-screen mode” + 1 overhead touch screen with no issue (image 1) IMAGES IN CLIP BELOW
On my new P3D V5.3 if I attempt to activate full screen the message “out of allocated memory” stops it from running.
When using Group View it works fine if I only adopt 3 monitors whether the top 3 or the lower 3 are used (fig 2 & 3)
However, if I make a 6 screes group, the two lateral lower screens seem to match the top image correctly but the bottom end seems to rotate spherically outwards (fig 4 & 5) like a wide-angle lens.
Tried on PMDG and the same happens (fig 6)
I was looking for the “pitch” values that used to be on previous versions but they are no longer there in V 5.3
Any idea of how I could rectify this problem would be greatly appreciated.
Many Thanks
Images here
https://youtu.be/amir6GM79Dk