Engine auto start ? 4.4

[Emile]

Hello,
After upgrade to 4.4 I have a small problem I must start the engines of the aircraft with "ctrl +e" ... this was not the case with 4.3.
How to autostart the engines?
Thanks in advance.

PS I run with 2D panels ...

[Rob McCarthy]

Hi Emile,

Are you only seeing this with specific vehicles?

Regards,
Rob McCarthy

[Emile]

Hi Rob,
I only tested the commander.
I did copy "my" panel 2D . I use this panel with all my addon aircraft swithout trouble.
With commander when the Sim start the engine is running but stops almost directly . Then I use "ctrl+E" , the engine starts with a lot of smoke black AND Grey... and stops after a few seconds, even when I increase the power. and so on, not possible to taxi and takeoff..
Thanks in advance

[zamirk]

Hi Emile,

Did you find any solution to this? I am having same issue...

Regards,
Zamirk

[Martyson]

Hello Zamirk ,

Is your default flight the P3D default flight (F-22 at KVPS)?

Does it load and fly ok?

[Chevalier]

Under Options/Realism, is automixture ticked?