Victoria Australia Composite Scenery

Forum for Prepar3D Developers to show off their work or post about their add-ons or content created for Prepar3D
NormanLGibson
Posts: 180
Joined: Sat Feb 04, 2012 2:41 am

Victoria Australia Composite Scenery

Postby NormanLGibson » Tue Mar 17, 2020 9:26 am

I have been experimenting with this technique and attach a few screenshots of what I have finally come up with. Since I am showing my scenery over ORBX AUv2, I have requested and have kindly received permission from ORBX. The scenery will work with default scenery, but ORBX is much superior.

The following screenshot shows a scenery layer containing just a composite of the imagery and underlying landclass water over Port Phillip Bay. The land is a composite of the imagery resampled at LOD 12 and as a complete Blended Mask shown over ORBX SCenery.
Image

The differences between waters can be seen below. The water below the aircraft is a composite whilst above the nose is not.
Image

The land below is ORBX AU2 which you will see from the cockpit around your aircraft. The composite can also be seen further out. Aircraft are flown from the cockpit thus you would normally only get this view if banking steeply.
Image

A video showing ORBX textures and autogen at low level then transitioning to imagery at higher altitude.
https://www.youtube.com/watch?v=iGxFGxR ... e=youtu.be

The size of the Victorian scenery will be under 1GB.

NormanLGibson
Posts: 180
Joined: Sat Feb 04, 2012 2:41 am

Re: Victoria Australia Composite Scenery

Postby NormanLGibson » Tue Mar 17, 2020 7:46 pm

A better shot of the water and coastline also showing the wave breaks adding to the scene.
In short, the water is a full composite resampled at LOD13, whilst the land is a composite resampled at LOD12, thus leaving the Landclass to mostly show below and around the aircraft at lower altitudes.
Image

The distant water has not yet been resampled.
Image

NormanLGibson
Posts: 180
Joined: Sat Feb 04, 2012 2:41 am

Re: Victoria Australia Composite Scenery

Postby NormanLGibson » Sun Mar 22, 2020 3:41 am

A few nice shots in the SE corner of the state.

The aircraft at 30,000ft.
Image

Image

Image

Lower altitude. ORBX AU2 in front of the wing with the composite above the wing tip. The change is hardly noticeable in this screenshot.
Image

NormanLGibson
Posts: 180
Joined: Sat Feb 04, 2012 2:41 am

Re: Victoria Australia Composite Scenery

Postby NormanLGibson » Tue Mar 24, 2020 2:14 am

East Coast complete
Image

Image

I have used a lighter shade of grey in the blend mask for these inland lakes as they are mostly grey/green
Image

NormanLGibson
Posts: 180
Joined: Sat Feb 04, 2012 2:41 am

Re: Victoria Australia Composite Scenery

Postby NormanLGibson » Sun Mar 29, 2020 9:07 am

Inland nearing completion. The composite water looks good, giving variations in the water colors.
Screenshots at 32,000ft.
Image

Image

Image

Image

Image


Return to “Development Showcase”

Who is online

Users browsing this forum: No registered users and 9 guests