Page 1 of 1

Low ftp on Multichannel

Posted: Tue Aug 25, 2020 11:59 am
by wuketing
I used 4 PCs (9700K,2080 graphics card,500G SSD,16G DDR4) for my simulator,I used Multichannel project.One PC for host and the other three PCs are for clients,each client connect to a projector.The problem is that, I got very low ftp(19-35),and it is not fluent at all,I try to set the World and the Traffic to the lowest ,but still can not get good performance.Would you plesase give me some advice?
Is the configuration of my PC suitable? Really gratefully if I can get the response. Thank you .

Re: Low ftp on Multichannel

Posted: Mon Sep 14, 2020 6:51 am
by JordanWihby
The thing with Multichannel, is that if you are not using Hardware Genlock (Quado GPUS) then your setup may not be stable in most cases. With multichannel setup, your fps is based on your computer that provides the lowest FPS. What I mean, is that if you host computer is capable of providing you with a stable 45-50 fps, but one of your client computers are only providing 25 fps, then your sim is going to run at 25 fps. Your configuration matches the computer that's least performing. Thats why multichannel is quite difficult, and better in my opinion (if you aren't using hardware gen locl) to have one main high end pc running your visuals. In the long run, it will save you money, and you will get better performance.

Re: Low ftp on Multichannel

Posted: Fri Sep 25, 2020 1:36 pm
by Beau Hollis
Can you provide some more details about your setup?
What graphics settings are you running?
What FPS are you getting in single channel setup?
How many displays are connected to each PC?
Is Vsync enabled?
Is variariable refresh rate enabled?
Are framerate limit settings being used?

Genlock will help keep images synchronized, but generally shouldn't impact performance. The system does wait for a ready signal from all clients before sending the message to start rendering a frame, so if any of the clients are running slow it will slow down the whole group.