P3D Pro Plus v5/HF1 -- F-22 wheel rendering problem

Any issues, problems or troubleshooting topics related to the additional features present in the Prepar3D Professional Plus client application.
Skonk
Posts: 7
Joined: Tue May 19, 2020 4:42 pm

P3D Pro Plus v5/HF1 -- F-22 wheel rendering problem

Postby Skonk » Tue May 19, 2020 5:43 pm

When flying any F-22 mesh, landing gear is not rendered when gear are extended in flight. Cockpit devices indicate gear are down - Three greens plus approach/landing HUD.

User avatar
Martyson
Posts: 10074
Joined: Sun Mar 25, 2012 11:08 am

Re: P3D Pro Plus v5/HF1 -- F-22 wheel rendering problem

Postby Martyson » Tue May 19, 2020 6:02 pm

When flying any F-22 mesh, landing gear is not rendered when gear are extended in flight. Cockpit devices indicate gear are down - Three greens plus approach/landing HUD.
At or below what speed / approach ?
Best Regards,
Vaughan Martell (KDTW)

Skonk
Posts: 7
Joined: Tue May 19, 2020 4:42 pm

Re: P3D Pro Plus v5/HF1 -- F-22 wheel rendering problem

Postby Skonk » Tue May 19, 2020 7:32 pm

I just re-flew my bug hunt cue card to see if I could reproduce the squawk. No issues on this run. Maybe my computer was resource starved earlier?.

Here's the hop details:
1. Depart KEDW
2. Climb to 5000 MSL
3. Get straight & level. Hold speed below 300 KCAS.
4. AP/HDG = ON. Hold heading
5. AP/ALT = ON. Hold Alt
6. Check gear extension V speeds (KCAS)
- 160/Gear lever down - Three greens - External views shows gear down / Reset cruise to 220 KCAS before next test
- 180/Gear lever down - Three greens - External views shows gear down / Reset cruise to 220 KCAS before next test
- 190/Gear lever down - Three greens - External views shows gear down / Reset cruise to 220 KCAS before next test
- 200/Gear lever down - Three greens - External views shows gear down / Reset cruise to 220 KCAS before next test
- 210/Gear lever down - NO GREENS - External views shows gear UP / Hold speed
- 210 + Boards down to 180/- Three greens @ 200KCAS and below - External views shows gear down
7. Configure AP/SPD for 300 KCAS
8. AP/SPD = ON. Establish speed
9. AP/SPD = ON. Set 200 KCAS. Turn on external view.
10. Pop boards and watch the gear/ Three greens @ 200KCAS and below - External views shows gear down
8. Land VFR/VMC


Return to “Prepar3D Professional Plus Client Application Questions”

Who is online

Users browsing this forum: No registered users and 21 guests