I just purchased KJFK V2 from FSDreamTeam but after the installation i found that the addon was in the addon manager and stating "ACTIVE" but not installed in scenery library, FSDreamTeam says its not there fault as it has been installed on my computer.
Any help would be appreciated.
Regards
TerenceJ
FSDreamTeam JFK V2 cannot add to scenery
Re: FSDreamTeam JFK V2 cannot add to scenery
Not sure if I understand you..
if it is listed on add-on manager and "Active" surely it should be working, what happens if you load your airplane inside KJFK?
Regards,
Simbol
if it is listed on add-on manager and "Active" surely it should be working, what happens if you load your airplane inside KJFK?
Regards,
Simbol
Re: FSDreamTeam JFK V2 cannot add to scenery
The FSDT installers use the recommend addon install steps in the SDK, and I've never had a problem installing any of their products. It is not installed via the scenery library (scenery.cfg); rather they use the add-on.xml auto discovery method. Read more about this in the Learning Center.
Alternatively, if you don't want to take the time to figure this out I recommend you use the Lorby Addon Organizer.
Alternatively, if you don't want to take the time to figure this out I recommend you use the Lorby Addon Organizer.
Dan Downs
KCRP
KCRP
Re: FSDreamTeam JFK V2 cannot add to scenery
If FSDT installs it using the xml method, that would explain why Terence doesn't see it in the scenery library.
Jorgen
Jorgen
Re: FSDreamTeam JFK V2 cannot add to scenery
Indeed, in hence why I am asking him to load his airplane at this location and confirm if he sees the desired airport working.If FSDT installs it using the xml method, that would explain why Terence doesn't see it in the scenery library.
Jorgen
S.
Return to “Prepar3D Installation and Installer Questions”
Who is online
Users browsing this forum: No registered users and 15 guests