CH Products or P3D problem?

Any issues, problems or troubleshooting topics related to computer hardware and the Prepar3D client application
LuxRalf
Posts: 15
Joined: Mon May 14, 2012 1:46 pm

Postby LuxRalf » Thu Nov 08, 2012 2:02 pm

Hi



I have the Fighterstick and the Eclipse yoke from CH Products.

When I am starting P3D the throttle is always full on and the elevator is on full down position.

After a bit of throttle it is all OK. Also with the elevator.



The elevator sometimes behaves strangely. When I pull the stick back, the elevator suddenly falls from the upper to the lower position.

And when I restart P3D, sometimes its all OK, sometimes not. :?



Is this a problem from CH Products or from the settings in P3D?



Ralf

Jude
Posts: 156
Joined: Fri Sep 14, 2012 5:09 pm

Postby Jude » Thu Nov 08, 2012 4:18 pm

Always a good idea to recalibrate the hardware.


LuxRalf
Posts: 15
Joined: Mon May 14, 2012 1:46 pm

Postby LuxRalf » Fri Nov 09, 2012 2:47 am

All done - same problem

Jude
Posts: 156
Joined: Fri Sep 14, 2012 5:09 pm

Postby Jude » Mon Nov 19, 2012 7:52 am

Are you using Windows 8 or other OS?

There are issues with Windows 8 OS at the moment regarding hardware.

LuxRalf
Posts: 15
Joined: Mon May 14, 2012 1:46 pm

Postby LuxRalf » Mon Nov 19, 2012 8:15 am

I am using Windows 7 64bit.



It's all OK when I disable FSUIPC (newest version)

Jude
Posts: 156
Joined: Fri Sep 14, 2012 5:09 pm

Postby Jude » Mon Nov 19, 2012 9:14 am

Aren't you on AVSIM too?

Sounds like you might need to contact FSUIPC developer.



Mit freundlichen Grüßen

LuxRalf
Posts: 15
Joined: Mon May 14, 2012 1:46 pm

Postby LuxRalf » Mon Nov 19, 2012 9:40 am

I am now registered in "Official Support Forum for FSUIPC" http://forum.simflight.com/forum/30-fsuipc-support-pete-dowson-modules/



I ask there and when I have a result, I will write it here down.

LuxRalf
Posts: 15
Joined: Mon May 14, 2012 1:46 pm

Postby LuxRalf » Wed Nov 21, 2012 4:30 am

Hi



Pete Dawson said that's a problem from P3D and CH Products but NOT of FSUIPC.

I have to eleminate the CH config manager and P3D (who is managing the axxes and buttons of joysticks,yokes, etc.).

It's a must to calibrate/manage the axes and buttons via FSUIPC.



Greatings

Ralf


Return to “Hardware Specific Questions”

Who is online

Users browsing this forum: Majestic-12 [Bot] and 10 guests