Controls Issue.

Any issues, problems or troubleshooting topics related to computer hardware and the Prepar3D client application
cliff
Posts: 75
Joined: Mon Sep 12, 2011 3:06 pm

Postby cliff » Fri Jun 22, 2012 5:06 pm

Hi All,



I have all the controls connected to P3D via a board from a throttle quadrant (Go Flight one!) this has all the Pitch/Roll/Rudder as well as engine throttles and Flaps.



Problem is that in the Config screen they work fine and look good range wise but in P3D they don't work properly Flaps movement hardly moves the flaps, Pitch is very poor very hard to get airborne even with full back pull on the controls. The engines won;t give full thrust and then reduce in power slowly after T/O with the throttles full forward.



Any Ideas?



I have been wondering if I should install FSUIPC as I have read this gives more control but I am hoping it's a quick fix that someone here can point out to me.



Thanks



Cliff.

Canuck
Posts: 207
Joined: Sat Mar 31, 2012 10:52 pm

Postby Canuck » Fri Jun 22, 2012 6:19 pm

Absolutely FSUIPC is a must for this and other issues..... btw I'm a customer no way involved with the program. I may be wrong but I think you have to pay for the full FSUIPC to access the control part of the program.

User avatar
janvaane
Posts: 918
Joined: Mon Apr 23, 2012 11:17 am
Contact:

Postby janvaane » Fri Jun 22, 2012 6:43 pm

Use FSUIPC http://www.schiratti.com/dowson.html

Some basics to get it up and running are here

http://janvaane.org/virtualfsx/?p=171

|KLM149 | i7-8700k-16GB | Radeon RX580 8GB| flightsimeindhoven.com |


Return to “Hardware Specific Questions”

Who is online

Users browsing this forum: No registered users and 38 guests