Trying to import set ups for honeycomb yoke and Throttle using the Honeycomb configurator. When activating basic throttle settings, it does not change P3D v4 axis or button sets. Any one give me a clue as to what I am not doing?
Thanks, any help would be much appreciated.
Honeycomb controllers
-
miraclemax
- Posts: 79
- Joined: Tue Aug 01, 2017 5:39 pm
Re: Honeycomb controllers
.I use P3Dv5.2HF1 with Honeycomb controllers; it may be the same for v4.5 though.
The Axis are assigned within P3d. If you download the HC setup files from Aerosoft site and install as instructed u should have no problem. Remember to select each profile within the HC configurator by going into PROFILES first and then into actions/activate; then activate the file. This must be done for both the throttle and the yolk. You CHANGE SELECTED DEVICE under ACTIONS.
Hope I have been of help. Regards,
max
The Axis are assigned within P3d. If you download the HC setup files from Aerosoft site and install as instructed u should have no problem. Remember to select each profile within the HC configurator by going into PROFILES first and then into actions/activate; then activate the file. This must be done for both the throttle and the yolk. You CHANGE SELECTED DEVICE under ACTIONS.
Hope I have been of help. Regards,
max
