Page 1 of 1

Posted: Wed May 08, 2013 3:50 pm
by wardorichie
Dear FS Community,



I cannot find any forums or steps on what pipeline to use, in order to bring in Animated Propellers, from 3ds Max to Prepar3d.



Aces Tools, I know the answer lives in here...however, I am not grasping onto the right method to make this work.



My model is very very simple......I have to Propellers, detached from a DA 42 twin. I have animated them.....very very sweet!



Now, I am pulling my hair out, I cannot export these correctly to get into Prepar3d.



Anyone have any suggestions as to where I can find some very clear instructions, as so I can master this process.



Thank you so much!!!



Rich

Posted: Wed May 08, 2013 4:00 pm
by WBard
Hey Rich -



have you looked in the modeling section of the SDK?



http://www.prepar3d.com/sdk/Environment%20Kit/Modeling%20SDK/new%20aircraft%20procedures.html



http://www.prepar3d.com/sdk/Environment%20Kit/Modeling%20SDK/Using%20Modeling%20Tools.html#Creating%20a%20New%20Animation

Posted: Wed May 08, 2013 4:17 pm
by wardorichie
Perfect, Thank you so much. The first html, I have not seen.....a ton of goodness lives in there, which will keep me busy.

You all rule!!!