Page 1 of 1

[RESOLVED] BGL Compiler

Posted: Sun Apr 14, 2019 11:01 pm
by n2airb
Since upgrading to 4.5 I am not able to convert SXML files to BGL. Has the Compiler in the SDK 4.5 changed? I used to use drag and drop, but now all i get is a command prompt window for a second and then it disappears and does not convert the file? Any Ideas would be greatly appreciated. Shawn

Re: BGL Compiler

Posted: Tue Apr 16, 2019 12:16 pm
by Rob McCarthy
Hello,

Thanks for the report. We'll investigate this on our end and get back to you. Can you PM me a link to your SXML file as well?

Regards,
Rob McCarthy

Re: BGL Compiler

Posted: Tue Apr 16, 2019 2:21 pm
by Rob McCarthy
Hello,

Another question, where is your SXML file located? When dragging and dropping files onto BGLComp it will output the BGL file to the same location as the SXML. If that file is located in your Program Files directory you may be running into admin rights issues. If you move the SXML file to your Documents folder do you still see this issue?

Regards,
Rob McCarthy

Re: BGL Compiler

Posted: Tue Apr 16, 2019 3:33 pm
by n2airb
Once I export the SXML file I move it from C:\Users\Shawn\Documents\Prepar3D v4 Files to C:\Program Files\Lockheed Martin\Prepar3D v4 SDK 4.5.11.29713\World\Scenery and from that point I drag and drop it into the BGL Compiler which in turn should convert the file to BGL within C:\Program Files\Lockheed Martin\Prepar3D v4 SDK 4.5.11.29713\World\Scenery but as I mentioned before I just get a Command prompt window for a second and no conversion. (Operating system is Windows 10)

Re: BGL Compiler

Posted: Tue Apr 16, 2019 3:42 pm
by n2airb
I have made sure that I have Admin Privileges on Prepar3dV4 and full read write security on the compiler. UAC is at "never Notify"

Re: BGL Compiler

Posted: Tue Apr 16, 2019 4:47 pm
by Rob McCarthy
Hello,

There still may be an issue writing to the Program Files directory using drag and drop. Does keeping the SXML in your "Documents\Prepar3D v4 Files" folder and dragging it from there onto BGLComp work as expected?

Regards,
Rob McCarthy

Re: BGL Compiler

Posted: Tue Apr 16, 2019 5:47 pm
by n2airb
No. I still just get the command prompt window and no conversion file.

Re: BGL Compiler

Posted: Wed Apr 17, 2019 2:02 pm
by n2airb
I moved the scenery folder that the BGL compiler resides in to my documents folder and the compiler worked. I haven't been able to figure out what is causing UAC not to allow permission to the folder when I have given full permission to the folder and UAC is at never notify? Thank you for your help. Shawn