Page 1 of 1

Engine auto start ? 4.4

Posted: Wed Dec 05, 2018 3:21 pm
by Emile
Hello,
After upgrade to 4.4 I have a small problem I must start the engines of the aircraft with "ctrl +e" ... this was not the case with 4.3.
How to autostart the engines?
Thanks in advance.

PS I run with 2D panels ...

Re: Engine auto start ? 4.4

Posted: Wed Dec 05, 2018 3:39 pm
by Rob McCarthy
Hi Emile,

Are you only seeing this with specific vehicles?

Regards,
Rob McCarthy

Re: Engine auto start ? 4.4

Posted: Wed Dec 05, 2018 4:45 pm
by Emile
Hi Rob,
I only tested the commander.
I did copy "my" panel 2D . I use this panel with all my addon aircraft swithout trouble.
With commander when the Sim start the engine is running but stops almost directly . Then I use "ctrl+E" , the engine starts with a lot of smoke black AND Grey... and stops after a few seconds, even when I increase the power. and so on, not possible to taxi and takeoff..
Thanks in advance