[RESOLVED] ADE signs & windsocks not showing up In P3D

wardorichie · Post by **wardorichie** » Fri Jun 07, 2013 10:09 am

Good Morning my Life Line to Flight Simulation Development!!

My current challenge...I am certain it is a very simple setting to toggle on and off.

In ADE, all my signs and windsocks are in place. Project compiles without issue. I have Prepare on 2 computers here in my office, I load my new .bgl into both simulators, one of them displays all of my signs and windsocks just fine.....the other, they are not visible.

I cannot find the setting anywhere to toggle these on and off, nor can I find the instructions to this setting.

Can someone please enlighten me?

Thank you so very much for your help!!!

Rich

Kamikaze · Post by **Kamikaze** » Fri Jun 07, 2013 10:42 am

Scenery density?

Maybe a texture problem?

wardorichie · Post by **wardorichie** » Fri Jun 07, 2013 1:02 pm

I realized that I had an error in one of my signs when compiling. Very strange how it worked on one computer and not another....however, once I addressed and fixed this error in one of the signs, ADE compiled out without errors. All is now showing up in simulator.

Thank you for your response Kamikaze.

Rich

Peter Dooley · Post by **Peter Dooley** » Wed Jan 15, 2014 5:25 am

Looks like this one is not resolved yet. I have noticed that the taxiway signs do not show up on the default airports either. Does anyone have any idea why?

ananda · Post by **ananda** » Wed Jan 15, 2014 7:33 am

Both display correctly here.