Hi,
I have installed the Hotfix 4.5 and notice a new thing as soon as when you change the autogen building level in P3D4.5 then click ok i have a CTD and P3D is closing!
It seems i am not alone to have this bug!
However performance are better than before the hotfix but for my part less good than 4.4 version with same settings!
Regards.
[RESOLVED] CTD when change Autogen building level with Hotfix P3D4.5 - unnamed add-on
- Brady Butler
- Lockheed Martin
- Posts: 965
- Joined: Tue May 09, 2017 5:31 pm
Re: CTD when change Autogen building level with Hotfix P3D4.5
Hello Jedi928,
We're not able to reproduce this in-house. To have us assist you further, could you please review this topic and let us know the results from following the troubleshooting steps?
http://www.prepar3d.com/forum/viewtopic ... 2&t=123246
If the issue is determined to be caused by an add-on, you will likely want to reach out to the add-on developer for direct support. If they need any support with development, they should not hesitate to contact us.
Regards,
Brady
We're not able to reproduce this in-house. To have us assist you further, could you please review this topic and let us know the results from following the troubleshooting steps?
http://www.prepar3d.com/forum/viewtopic ... 2&t=123246
If the issue is determined to be caused by an add-on, you will likely want to reach out to the add-on developer for direct support. If they need any support with development, they should not hesitate to contact us.
Regards,
Brady
Brady Butler
Prepar3D® Software Engineer
Prepar3D® Software Engineer
Re: CTD when change Autogen building level with Hotfix P3D4.5
Thanks for your support i have identified the add-on who cause this problem i didn't have before hotfix so i have mailed the problem to the developper…
Best regards.
Best regards.