Native Handling of Rotary Encoders

Post your feature requests here. Note that we cannot promise that any of these posts will be commented on or that requested features will be implemented.
User avatar
scottb613
Posts: 13
Joined: Tue May 10, 2016 2:35 pm

Native Handling of Rotary Encoders

Postby scottb613 » Mon Sep 23, 2019 1:00 pm

Hi Folks,

Could we get native handling of Rotary Encoders in P3D - so may knobs in the cockpit are of a the rotary type - however - P3D is unable to use any hardware of the same type natively... In order to get this to work - we have to delve into LUA scripting to attempt to capture the rate of change in order to come up with a logical increment that works in the VC... Fast rate of change = large jumps to get around the dial efficiently... I'm sure LM is far better at coming up with solutions for this than I - so please consider addressing this in a future update...

Thanks...

Regards,
Scott

Return to “Prepar3D Feature Requests”

Who is online

Users browsing this forum: No registered users and 5 guests