Page 1 of 1

Posted: Sun Dec 01, 2013 2:40 am
by PeterWebber
Good day..

I have already configured my Saitek Yoke and Throttles successfully....My rudder pedals are problematic...prepar3d v2 recognises the rudders in the controller setup, but if i try to assign the pedals and toe brakes, it brings up the throttle quadrant axis....v1.4 lists 'toe brake' when i press the pedals....v2.0 brings up x and y axis, which is from the throttles...it does not give an option of toe brakes...it thinks i'm operating the throttles although i'm pushing the pedals....any ideas?