I have all the controls connected to P3D via a board from a throttle quadrant (Go Flight one!) this has all the Pitch/Roll/Rudder as well as engine throttles and Flaps.
Problem is that in the Config screen they work fine and look good range wise but in P3D they don't work properly Flaps movement hardly moves the flaps, Pitch is very poor very hard to get airborne even with full back pull on the controls. The engines won;t give full thrust and then reduce in power slowly after T/O with the throttles full forward.
I have been wondering if I should install FSUIPC as I have read this gives more control but I am hoping it's a quick fix that someone here can point out to me.
Any issues, problems or troubleshooting topics related to computer hardware and the Prepar3D client application
3 posts • Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 27 guests