Throttle Moving to Reverse Thrust

[bigmarty]

I am using my new Bravo throttle quadrant and dont know if my problem is related to the Bravo or something else. I did not have this issue with my previous quadrant. I have posted this on the Aerosoft forum as well to see if anyone has experienced the same issue after changing to the Bravo.

I doesn't seem to matter how I set up the throttles - sim, FSUIPC, Lorby si; and either one lever controls both throttles or separate, the throttles will move to full and stay there, but pulling back to idle throttle 2 slowly slides into reverse thrust position. Is happening on my Aerosoft Twin Otter and same thing on the Majestic Q400. Changing null zone and sensitivity makes no difference.

Has anyone seen this before and have a fix in mind?
Any suggestions would be appreciated.

Martin

[bigmarty]

I ran the 'repair' function on the P3D installation and the problem seems to have gone away. Hope it stays that way.

Martin