Prepar3D Forums

I have uninstalled P3D from the C: drive in order to reinstall it again in d: drive (space issues). But when the installation have been running several minutes I receive an error message:



"Error 1907. Could not register font. Verify that you have sufficient permission to install fonts, and that the system supports this font"



If I select Ignore it comes again the same message several times and finally it appears. "Error 2902. Operation ixoFileCopy called out of sequence" and teh instalñlataion finishes



I am using windows 7 64bits and I run the setup.exe as adminstrator.



I will appreciate any clue for solving this



Thanks in advance



Carmelo

doing it in admin mode?

Ye, I run Setup.exe with admin rigths

Then you are trying to unzip the files from the wrong directory. Please proceed exactly as shown in the documentation.

use ccleaner to clean temp files, cache and registry.

http://www.piriform.com/ccleaner/download/standard





check for this folders and delete them if you find them:



C:\Program Files (x86)\Lockheed Martin\Prepar3D (or the modified install location)

C:\ProgramData\Lockheed Martin\Prepar3D

C:\Users\*USERNAME*\AppData\Local\Lockheed Martin\Prepar3D

C:\Users\*USERNAME*\AppData\Roaming\Lockheed Martin\Prepar3D

C:\Users\*USERNAME*\Documents\Prepar3D Files



Then reinstall Prepar3d.



Good Luck.



Alex

Celis, Kamikaze



thank you very much for your help. I downloaded again the three files and extract them in a new folder. Everything went ok.



I am enjoying P3D once again



Carmelo