Page 1 of 1
Building database for new scenery files
Posted: Wed Sep 16, 2020 5:39 pm
by Daviletis
Every time I run the prepar3d v5 the following message appears: Building database for new scenery files. This process may take a few moments. I have nothing installed, just the simulator.Then I can use it without problems.
Is normal? It is the first time that I use prepar3d.With FSX it only happened if you installed something new.
Regards
Re: Building database for new scenery files
Posted: Wed Sep 16, 2020 10:02 pm
by Alox
This should only happen when you install or uninstall a scenario such as: Orbx, LatinVFR, PILOT'S FSG - FS GLOBAL ULTIMATE.
Have you tried deleting the file scenery.cgf on C:\ProgramData\Lockheed Martin\Prepar3D v5, then try to run P3D V5 again in order that this file can regenerate again.
Regards.
Re: Building database for new scenery files
Posted: Thu Sep 17, 2020 7:07 am
by JorgenSA
Daviletis,
You are correct, the behavior should be the same as in FSX. In P3D, both in v. 4 and v. 5, I have only seen it the same way as FSX, so I am wondering what could be going on in your system....
Jorgen
Re: Building database for new scenery files
Posted: Thu Sep 17, 2020 8:34 am
by Martyson
@ Daviletis ,
Did you just install P3Dv5 yesterday?
Re: Building database for new scenery files
Posted: Thu Sep 17, 2020 5:25 pm
by Daviletis
I have tried deleting the cfg file and it keeps doing the same.
I have it installed from 2 weeks ago.
I do not understand anything. I haven't installed anything and every time I run Prepar 3d it happens
I think I'll end up uninstalling it and doing another clean install. Although I would like to know why it happens.
Thanks to everyone for your help me
Re: Building database for new scenery files
Posted: Thu Jul 14, 2022 1:32 pm
by Fafo
I have never encountered such bugs with prepar3d.