Page 1 of 1

[RESOLVED] Unable to use mouse wheel for knobs in VC

Posted: Thu May 28, 2020 9:07 am
by RhysCPFC
Hello, in P3D v5 I am completely unable to use my mouse wheel for turning knobs in the virtual cockpit, this was never a problem in v4 but even after a reinstall it is impossible in v5; i can still use left and right click for them however so flying is not impossible. i have disabled and enabled advanced mouse controls to no avail as well. Any help would be great, thanks

Re: Unable to use mouse wheel for knobs in VC

Posted: Fri May 29, 2020 7:36 pm
by Rob McCarthy
Hello,

Does the solution in this post help with your issue?
https://prepar3d.com/forum/viewtopic.ph ... ilit=Knobs

Regards,
Rob McCarthy

Re: Unable to use mouse wheel for knobs in VC

Posted: Mon Jun 01, 2020 3:34 pm
by RhysCPFC
No because all he said was that he deleted his mouse control software but idk what he means by that, was gonna ask before making this post but it was closed so i had to make this one

Re: Unable to use mouse wheel for knobs in VC

Posted: Mon Jun 01, 2020 8:01 pm
by Rob McCarthy
Are you only seeing this issue with specific aircraft?

Regards,
Rob McCarthy

Re: Unable to use mouse wheel for knobs in VC

Posted: Tue Jun 02, 2020 11:19 am
by RhysCPFC
Nah it is all aircraft unfortunately, default and addon

Re: Unable to use mouse wheel for knobs in VC

Posted: Tue Jun 02, 2020 7:24 pm
by RhysCPFC
Fixed it, checked my pc and at some point i installed a program called x-mouse control; this seemed to cause the issue for anyone else experiencing; just un install and it will fix it!