Gate Positions when connected to VATSIM via vPilot

Other problems or issues not covered by other troubleshooting topics.
CptChoppa
Posts: 2
Joined: Sat Jun 25, 2016 10:03 pm

Gate Positions when connected to VATSIM via vPilot

Postby CptChoppa » Sat Jun 25, 2016 11:25 pm

Hey Guys,

I am very confused. When I load up my flight in P3D the gate position is perfectly fine. But when I connect to VATSIM via vPilot all the other aircrafts are way off the gate positions. I talked to a ground controller and it seems that it's my position which is off. But on my screen in P3D my position is fine and the gate "is in my favor".

Any suggestions? I am really struggeling here.

Thx in advance.
Best regards,
CptChoppa

Mike LM
Posts: 1344
Joined: Mon Jul 20, 2015 5:26 pm

Re: Gate Positions when connected to VATSIM via vPilot

Postby Mike LM » Thu Jul 07, 2016 2:04 pm

CaptChoppa -

I would guess that you're using an add-on that changes the position of the gate, or the ground controller is using an add-on with different positions. Make sure that you're on the same page about which add-ons to use.

If you're both using the same add-ons, then something may be messed up with the communication between your system and theirs.

- Mike
Prepar3D® Software Engineer


Return to “Other Support Questions”

Who is online

Users browsing this forum: No registered users and 43 guests