Nose down ... trim very hard to adjust

oliver77 · Post by **oliver77** » Thu Dec 05, 2013 2:40 pm

Hi there,

A very strange behavior of my planes:

Whatever the plane, in FSX, I have to trim the elevator, but I don't need to pull the yoke as much as in P3DV2.

In P3D, i have to try and trim a long time to be able to let go off the yoke... The nose of my plane will go to the ground... Very hard to land ... Nose is going down ...

Any idea ?

thanks...

petar91 · Post by **petar91** » Sat Dec 07, 2013 12:13 pm

Hi Oliver,

i think i have the same problem than yours, but no answer to my topic :

http://www.prepar3d.com/forum-5/?mingle ... pic&t=4145

oliver77 · Post by **oliver77** » Sat Dec 07, 2013 5:50 pm

Hi Petar91,

You're right, we have the same problem. Acually, elevator trim si set on "full nose down".

I have to check if this behavior is the same with or without my joystick.

X52 or Pro Flight Yoke : Same behavior....

I've created a new topic : http://www.prepar3d.com/forum-5/?mingle ... stid-20698