Milviz Beaver & Otter issues after v4.2 Client Update

[Eagle Spirit]

After holding off from updating for fear of potential issues, I ultimately did the update a few days ago. Now I seem to have some issues.

I wanted to alert you about issues I'm having with my Beaver and Otter since installing the update. These issues have only appeared with these two. No other product names appear to be affected to this date, however, I haven't flown that much.

The issue is that the fuel tank selector and magneto don't work. No matter the selection, they show as off. The magneto selection doesn't effect the engine running or not.

The Otter acted erratically, jumping all over the tarmac, basically out of control. On later attempts, it seemed to perform normally, except for the fuel selector and magneto.

I have not flown any of my other MV AC to see if the issue exists. The issue does not exist in other developers AC.

I was very leary of doing this v4.2 update, so held off doing it until a few days ago, but I was assured it was trouble free.

I've contacted Milviz.

Regards, Scott