Page 1 of 1

Smokesystem Locations in v5

Posted: Mon May 04, 2020 3:37 am
by Malin2
Is there a way to get the [SMOKESYSTEM] effects to show up at the locations indicated in the aircraft.cfg, without attaching them directly to the model?

Without direct attachment, they show approximately 20 feet to the rear of their indicated locations, and slightly to one side. If the corrections to location are written in the aircraft.cfg, the corrections work up until a point and then become too far forward. It seems impossible to move the effects to the correct location.

With direct attachment, then the parts of the effect that should move forward now move rearwards. The effect doesn't work correctly any more. The effect itself works just fine if not attached, it just appears in the wrong location.

Thanks!