There are missing runways and taxiways at KORD. Since this is a major airport is there any fixes for KORD?
Thanks,
Tom
Missing runways and taxi way at KORD
-
- Posts: 8
- Joined: Wed Jun 21, 2017 4:09 pm
Re: Missing runways and taxi way at KORD
Tom
I think you need to give a little more information. Are you using the default scenery for KORD or another version.
Dave Butler
I think you need to give a little more information. Are you using the default scenery for KORD or another version.
Dave Butler
Re: Missing runways and taxi way at KORD
I am using the default scenery that comes with P3Dv4. The vendor KORD scenery are only a little better.
http://155.178.201.160/d-tpp/1709/00166AD.PDF is the current KORD airfield. I found the problem when I was vectored in for a 27L approach and no published ILS frequency was picked up by my aircraft. Looking down I did not see the runway.
Thanks,
Tom
http://155.178.201.160/d-tpp/1709/00166AD.PDF is the current KORD airfield. I found the problem when I was vectored in for a 27L approach and no published ILS frequency was picked up by my aircraft. Looking down I did not see the runway.
Thanks,
Tom
Re: Missing runways and taxi way at KORD
Correction: I was trying to land on 27R at the most northern part of the field.
-
- Posts: 8
- Joined: Wed Jun 21, 2017 4:09 pm
Re: Missing runways and taxi way at KORD
The real R27R does not seem to have been included in the default scenery. If you use Aircraft Scenery Designer and load the default scenery for KORD it only shows 6 runways.
Dave Butler
Dave Butler
Re: Missing runways and taxi way at KORD
Yes, you are correct. Is LM going to update the the default KORD so that useful training can take place at KORD.
Thanks,
Tom
Thanks,
Tom
Re: Missing runways and taxi way at KORD
I'm using Ray Smith's FSX version of KORD in v4. I had to correct a couple of the links using ADE 1.75. Like all Ray's stuff it works just fine.
blaustern
blaustern