You need more memory... or turn down graphics settings.

Is there anyone at L-M willing to discuss this situation?

Ok... I'll answer my own question: Torque is directly tied to corrected N1 in the sim. So, the only way to control the torque behavior is to control the N1 behavior. Unfortunately, the sim does not allow for good control over the N1 behavior (PID type behaviors), so torque bounces around because N1 ...

Can anyone provide information regarding what impacts the turboprop engine's torque response to throttle changes? In other words, how quickly or slowly it responds and how to adjust that and avoid any overshoot.

When you turn on the engine anti-ice in a turboprop (to simulate the behavior of an inertial separator)... it causes a significant drop in engine torque. Torque should drop about 6% or 7%... but instead it is droping almost 50%.

Is there something that can be done to adjust this behavior?

I think you would do better setting the elevator axis input instead of the reported elevator position.

It would be AIRSPEED INDICATED:1 or AIRSPEED INDICATED:2

# (>K:KOHLSMAN_INC, number) where # is the altimeter number you want to adjust.

I am assuming you are using the MAGNETO_INCR and MAGNETO_DECR events to adjust the magneto setting. There are also individual events defined for each possible position.

• MAGNETO1_OFF

• MAGNETO1_RIGHT

• MAGNETO1_LEFT

• MAGNETO1_BOTH

• MAGNETO1_START

I am talking about separate altimeters defined in the aircraft.cfg. If that isn't done, then there is only one baro setting for the aircraft.

That should work, as long as there are separate altimeters defined for the aircraft.

You need to get support from Cera Simccraft... it is their product that is not installed correctly.

I'm running quad channel memory and I moved from 16gb to 32gb and saw a significant improvement in performance. It's not all about the foreground application here folks.

Sorry, I meant Pro Plus... typo on my part.

You would be mistaken. I have other software than JUST the sim running by default and it is necessary software.

Professional version should actually correct the issue. It allows one computer to be the master and the other one to be the slave.